Feet to Yards Converter
Convert feet to yards. The formula used here is 1 foot = 0.333333333333 yards. The formula is yd = ft × 0.333333333333; 1 ft is 0.333333 yd.
A US customary and imperial length unit equal to 12 inches.
A US customary and imperial length unit equal to 3 feet.
Start with your value in feet, then apply the formula below. It stays visible so you can catch rounding mistakes instead of just copying the output.
When the converted length drives a cut, fit, clearance, or route estimate, decide whether to round to the nearest mark, round up for safety, or keep decimals for documentation.
Many length factors are exact by definition, but practical measurements still depend on rulers, survey tools, tolerances, and how the result will be used. This page displays converted values with up to 6 decimal places by default.
| Feet | Yards |
|---|---|
| 1 ft | 0.333333 yd |
| 3 ft | 1 yd |
| 6 ft | 2 yd |
| 10 ft | 3.333333 yd |
| 100 ft | 33.333333 yd |
Useful for checking construction and DIY measurements. Use the same formula with your exact input if the measurement needs to be documented.
Useful for travel, mapping, or athletics distances. Use the same formula with your exact input if the measurement needs to be documented.
Useful for product dimensions and classroom conversions. Use the same formula with your exact input if the measurement needs to be documented.
How do I convert feet to yards?
Enter the value in feet and apply yd = ft × 0.333333333333. Round the yards result after the conversion, not before.
What is 1 foot in yards?
1 ft equals 0.333333 yd with the current rounding setting. Keep more decimal places when the result feeds another calculation.
What is 3 ft in yd?
3 ft is 1 yd. It appears in the lookup table so you can compare it with nearby amounts.
Can I convert yards back to feet?
Yes. Use the reverse Yards to Feet converter if you need to go the other direction.
How accurate is this feet to yards conversion?
The calculator runs the formula in your browser and rounds results to 6 decimal places by default. Many length factors are exact by definition, but practical measurements still depend on rulers, survey tools, tolerances, and how the result will be used.