Inches to Feet Converter
Convert inches to feet. The formula used here is 1 inch = 0.0833333333333 feet. The formula is ft = in × 0.0833333333333; 1 in is 0.083333 ft.
A US customary and imperial length unit equal to 1/12 of a foot.
A US customary and imperial length unit equal to 12 inches.
Start with your value in inches, then apply the formula below. It stays visible so you can catch rounding mistakes instead of just copying the output.
When the converted length drives a cut, fit, clearance, or route estimate, decide whether to round to the nearest mark, round up for safety, or keep decimals for documentation.
Many length factors are exact by definition, but practical measurements still depend on rulers, survey tools, tolerances, and how the result will be used. This page displays converted values with up to 6 decimal places by default.
| Inches | Feet |
|---|---|
| 1 in | 0.083333 ft |
| 6 in | 0.5 ft |
| 12 in | 1 ft |
| 24 in | 2 ft |
| 36 in | 3 ft |
Useful for checking construction and DIY measurements. Use the same formula with your exact input if the measurement needs to be documented.
Useful for travel, mapping, or athletics distances. Use the same formula with your exact input if the measurement needs to be documented.
Useful for product dimensions and classroom conversions. Use the same formula with your exact input if the measurement needs to be documented.
How do I convert inches to feet?
Enter the value in inches and apply ft = in × 0.0833333333333. Round the feet result after the conversion, not before.
What is 1 inch in feet?
1 in equals 0.083333 ft with the current rounding setting. Keep more decimal places when the result feeds another calculation.
What is 6 in in ft?
6 in is 0.5 ft. It appears in the lookup table so you can compare it with nearby amounts.
Can I convert feet back to inches?
Yes. Use the reverse Feet to Inches converter if you need to go the other direction.
How accurate is this inches to feet conversion?
The calculator runs the formula in your browser and rounds results to 6 decimal places by default. Many length factors are exact by definition, but practical measurements still depend on rulers, survey tools, tolerances, and how the result will be used.